15035 Impact given in inches Table 1-1 / 2, 6 tips, 2-3 / 16

• The URREA line of 6-point impact sockets distributes the forces in the lobes in the geometry, allowing greater speed to fit into hexagonal and square nuts and/or screws, thanks to its geometry
• They have a resistant phosphatized finish
• They are precisely machined and heat treated to provide the best combination of hardness, toughness and torsional resistance
• They present a great variety and depth of dashboards

DISCONTINUED

• Urrea sockets have a super-Drive® design that prolongs its life and does not damage the screws and nuts and bolts
• Urrea sockets have a resistant phosphatized to finish recommended in case of FOD (foreign object detachment)
• It is recommended to use sockets with phosphatized finish prevent the shedding of coating particles
• Urrea products is reinforced by showing an indelible and permanent mark with the country of origin
• This meets ASME / ANSE norms, as well as rules established by the federal Trade Commission in the United States
• Opening size: 7/16"
• Type: II
• Length: 15/16"
• Nut end outside diameter: 5/8"
• Drive end outside diameter: 5/8"
• Nut deep: 1/4"

DISCONTINUED

DISCONTINUED

• Urrea wrenches are manufactured under ASME B107
• 100 specifications and incorporate the UGS system on all open-ends
• UGS system was designed and patented by Urrea, which offers the following benefits: If a nut or a bolt's edges are stripped, the 3-point contact distribution ensures that there is enough not contact to tighten or loosen
• When torque is applied, the force is distributed to three points, thus reducing stress on the nut or bolt edges
• Opening size: 70 mm
• Total length: 32-1/2"

DISCONTINUED