DD5108 1/8 IN TITANIUM IR DRILL BIT

• Offset design in these wrenches (opening angle to wrench handle) allows it to be used in places where there is a partial obstruction
• Its structure and design allows it to be hit strongly in order to loosen nuts
• Greater impact surface than conventional striking wrenches
• Opening size: 2-1/8"
• Total length: 14"

• Ergonomic design provides greater contact area, minimizing the effort required to use them while decreasing the fatigue felt from continuous use
• Electrician or linemans pliers offer 46% greater strength and cutting force than conventional pliers
• Ergonomic design with safe handles and striated jaws
• Exceed ASME B107
• 500 standard
• Total length: 8-17/32"
• Jaw width: 2-1/4"
• Jaw thickness: 9/16"
• Maximum opening: 1-1/64"

• - Aluminum level bar 18 Surtek,- Vertical, horizontal and 45° bubbles with wide window for easy reading,- Made of injected aluminum,- Interchangeable bubbles with higher resistance to abrasion and to impact

• Urrea sockets have a super-Drive® design that prolongs its life and does not damage the screws and nuts and bolts
• Urrea sockets have a resistant phosphatized to finish recommended in case of FOD (foreign object detachment)
• It is recommended to use sockets with phosphatized finish prevent the shedding of coating particles
• Urrea products is reinforced by showing an indelible and permanent mark with the country of origin
• This meets ASME / ANSE norms, as well as rules established by the federal Trade Commission in the United States
• Opening size: 1-3/8"
• Type: I
• Length: 2-15/16"
• Nut end outside diameter: 2-3/8"
• Drive end outside diameter: 3-7/16"
• Nut deep: 3/4"

DISCONTINUED