22191-00 NUT, CLAMP

• Urrea sockets have a super-Drive® design that prolongs its life and does not damage the screws and nuts and bolts
• Urrea sockets have a resistant phosphatized to finish recommended in case of FOD (foreign object detachment)
• It is recommended to use sockets with phosphatized finish prevent the shedding of coating particles
• Urrea products is reinforced by showing an indelible and permanent mark with the country of origin
• This meets ASME / ANSE norms, as well as rules established by the federal Trade Commission in the United States
• Opening size: 1-1/2"
• Type: II
• Length: 3-1/2"
• Nut end outside diameter: 2-1/4"
• Drive end outside diameter: 2-1/4"
• Nut deep: 1-3/16"

• A wrench can be used on square shank for extra torque transmission
• Handle with trilobular design brings more confort and better toque transmission
• Exceed ASME B107
• 600, ISO 2380-1 & ISO 8764-1 standards
• Tip size: PH2
• Exposed length: 1-3/8"
• Total Length: 3-7/8"

• Phosphatized finish offers greater protection against corrosion
• T-handle design allows greater torque application
• Tip size: 6 mm
• Length: 6"
• Handle size: 4"

DISCONTINUED

• Replacement blade
• Cuts and strips round and flat cable
• Stripping length 1/2 "and 1/4"
• Crimping dies are precision ground from high-carbon steel
• Ratcheting system for uniform pressure