90599391 WARNING LABEL

• Straight drift pin
• Drift pins are used to install or remove guide bushings, pins, and center guides
• Their length is important and it depends on the job
• Straight pins can also be used to align holes when assembling parts
• Straight tip, ideal for installing or removing guide bushings when die-cutting
• The tool's butt end is designed to withstand strikes
• Tapered tip, ideal for installing or removing pins and center guides in deep holes
• Width: 3/8"
• Tip size: 3/16"
• Total length: 6-1/8"

Motion Sensor, Classic Line, Volteck

DISCONTINUED

• Urrea sockets have a super-Drive® design that prolongs its life and does not damage the screws and nuts and bolts
• Urrea sockets have a resistant phosphatized to finish recommended in case of FOD (foreign object detachment)
• It is recommended to use sockets with phosphatized finish prevent the shedding of coating particles
• Urrea products is reinforced by showing an indelible and permanent mark with the country of origin
• This meets ASME / ANSE norms, as well as rules established by the federal Trade Commission in the United States
• Opening size: 1-9/16"
• Type: III
• Length: 2-5/16"
• Nut end outside diameter: 2-3/8"
• Drive end outside diameter: 1-3/4"
• Nut deep: 1-3/8"